WUXI XINDU TELEMECANIQUE CO.LTD

High quality products, professional services, is the core supplier of the clutch industry!

Home > Exhibition > Content
How to adjust the clearance between the screw and brake rod of the LG washing machine clutch?
- Nov 24, 2017 -


In the operation of the washing machine, if the clearance between the adjusting screw and the brake rod is not reasonable, it will cause different fault conditions.

The small clearance may cause the washing machine to extend the brake time, that is, the load braking time of the washing machine is more than 10 seconds. If the situation is more serious, then the washing impeller may operate only in one direction. In view of this problem, we should remove the triangular belt in time, at this point should pay attention to checking the direction of the motor. If the operation is in the correct direction, it should also be checked whether the pawl of the LG washing machine clutch has set the ratchet over enough angle in the washing state.

If the ratchet wheel is not used, or does not meet the requirements, it may cause the rectangular wire clutch spring still wind on the clutch sleeve. In this case, if the washing machine motor turns clockwise, the large pulley is stuck and cannot turn. So we need to readjust the clearance between the adjusting screw and brake rod. Remember that the distance between the adjusting screw and the brake rod should be increased appropriately at this time, while ensuring that the dehydration condition is normal.

Then, if the clearance between the adjusting screw and brake rod of the LG washing machine clutch is too large, we need to tighten the adjusting screw to the inside to reduce the distance between the adjusting screw and brake rod. Normally, the distance between the adjusting screw and the brake rod of the LG washing machine clutch should be kept between 0.5 and 1mm.


http://clutchwxxindu.com/