WUXI XINDU TELEMECANIQUE CO.LTD

High quality products, professional services, is the core supplier of the clutch industry!

Home > Exhibition > Content
LG speed reducer washing machine part use principle and installation steps
- Nov 23, 2018 -

LG speed reducer washing machine part exist in many electrical appliances, and the reducer can make the machine itself and the working machine directly play a role of connection and partition. With the reducer, you can meet the various needs of your work.

The reducer inside the LG reducer washing machine accessory is a separate rotating accessory between the washing machine motor and the pulsator. Its main function is to decelerate and increase the power, thus driving the pulsator to rotate, so that the rotating drum is stopped immediately. The principle of the reducer is the same as that of the bicycle brake.

 

LG speed reducer washing machine part will have the existence of reducer in many electrical devices. These are not known to many consumers. If there is no reducer in the washing machine, there is no way to stop the operation quickly, not only will it consume a lot of Electricity, but also cause the washing machine to idling, so the reducer is very important for the washing machine.

 

LG Speed Reducer Washing Machine Part Installation Steps

1. Disconnect the power first;

2. Use a screwdriver to loosen the screw on the left side;

3. Use a screwdriver to loosen the screw on the right side;

4. Extend the hand to the gap between the upper cover and the outer bucket, and use your fingers to open the front and rear buckles on the left and right sides;

5. Then remove the front cover;

6. Loosen the three screws on the top cover of the washing machine;

7. Remove the rear cover;

8. Unscrew the screws inside the four corner holes;

9. Loosen the screws on the back cover and open the back cover;

10. Pick up the top cover and lean on the stool;

11. Loosen the four screws on the outer tub cover;

12. After removing the outer cover, unscrew the screw in the middle of the pulsator;

13. Screw the large nut out of the tool to install the reducer.

 

https://www.clutchwxxindu.com/