Main installation steps of the gearbox speed reducer for washing machine

1. Disconnect the power first.

2. Use a screwdriver to loosen the screws on the left and right sides.

3. Reach out into the gap between the top cover and the outer tub and use your fingers to open the front and rear sides of the front cover buckle.

4. Then remove the front cover.

5. Loosen the three screws on the top cover of the washing machine.

6. Remove the rear cover.

7. Unscrew the screws inside the four corner holes.

8. Loosen the screws on the back cover and open the back cover.

9. Pick up the top cover and lean on the stool.

10. Loosen the four screws on the outer tub cover.

11. After removing the outer cover, unscrew the screw in the middle of the pulsator.

12. Loosen the screw and take the 珐 珐 珐 貉攉 瘫氦 瘫氦.

13. Screw the large nut out of the tool to install the reducer.

https://www.clutchwxxindu.com/